SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
Fastener tightening specifications are provided so cooling system and related engine heating/cooling components can
COOLING SYSTEM DRAINING AND FILLING (STATIC FILL)
Draining Procedure
Special Tools
J 26568 Coolant and Battery Tester
WARNING: To avoid being burned, do not remove the radiator cap or surge
tank c
Removing Tools
The tools needed to remove the spare tire are located in the storage compartment on the driver side, at the rear of the vehicle. Before beginning, make sure the vehicle is parked in a safe, level area, the hazard warning flashers are on, and passengers are away from traffic.
The tool
* PLEASE READ THIS FIRST *
NOTE: The following oil pump information is general in nature and is intended to explain common measuring and evaluation practices used during engine overhaul. Pump construction, service limits, and replacement procedures vary by engine design.
Always refer to the appropri
Specifications, Diagnostic Information and Procedures